Details

---

BUY S4055R https://www.utsource.net/itm/p/12611260.html

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Collector-Emitter Voltage	VCEO	-	-	30	V	IC = 0, TA = 25掳C
Collector-Base Voltage	VCBO	-	-	40	V	IE = 0, TA = 25掳C
Emitter-Base Voltage	VEBO	-	-	5	V	IC = 0, TA = 25掳C
Collector Current	IC	-	-	100	mA	VCE = 5V, TA = 25掳C
Base Current	IB	-	-	5	mA	VCE = 5V, TA = 25掳C
DC Current Gain	hFE	10	100	300	-	IC = 10mA, VCE = 5V, TA = 25掳C
Transition Frequency	fT	-	300	-	MHz	IC = 10mA, VCE = 5V, TA = 25掳C
Storage Temperature Range	TSTG	-65	-	150	掳C	-
Operating Temperature Range	TA	-55	-	150	掳C	-

Instructions for Use:

1. Mounting:

   • Ensure the S4055R is mounted on a suitable PCB with appropriate thermal management.
   • Avoid mechanical stress on the leads during soldering.

2. Soldering:

   • Use a temperature-controlled soldering iron.
   • Soldering temperature should not exceed 300掳C.
   • Soldering time should be kept to a minimum (less than 3 seconds per lead).

3. Electrical Connections:

   • Connect the collector (C) to the load or power supply.
   • Connect the base (B) to the control signal.
   • Connect the emitter (E) to ground or the common point.

4. Biasing:

   • Ensure the base-emitter voltage (V_BE) is within the specified range to avoid damage.
   • Use a current-limiting resistor in series with the base to prevent excessive base current.

5. Heat Dissipation:

   • If the transistor will be operating at high currents or temperatures, consider using a heatsink.
   • Ensure adequate ventilation if the device is used in a closed enclosure.

6. Storage:

   • Store the S4055R in a dry, cool place away from direct sunlight.
   • Handle with care to avoid static discharge, which can damage the device.

7. Testing:

   • Before final assembly, test the transistor using a multimeter or a transistor tester to ensure it meets the specified parameters.
   • Check for any short circuits or open circuits in the connections.

8. Safety:

   • Always follow proper electrical safety guidelines when working with transistors.
   • Use protective equipment such as gloves and goggles when handling the device.

(For reference only)