Details

---

BUY ML4824IP1 https://www.utsource.net/itm/p/12611336.html

Parameter	Symbol	Min	Typical	Max	Unit
Supply Voltage	Vcc	4.5	-	5.5	V
Operating Temperature	Topr	-40	-	85	°C
Storage Temperature	Tstg	-65	-	150	°C
Output Current (Max)	Iout	-	50	100	mA
Quiescent Current	Iq	-	10	20	μA
Shutdown Current	Isd	-	0.1	1	μA
Output Voltage (Min)	Voutmin	1.2	-	-	V
Output Voltage (Max)	Voutmax	-	-	5.5	V
Dropout Voltage	Vdo	-	200	300	mV
Load Regulation	ΔVout/ΔIout	-	0.5	1	mV/mA
Line Regulation	ΔVout/ΔVin	-	0.5	1	mV/V
PSRR (1 kHz)	PSRR	-	70	-	dB
Thermal Resistance (θJA)	θJA	-	150	-	°C/W

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (Vcc) is within the range of 4.5V to 5.5V.
   • Use appropriate decoupling capacitors (typically 100nF and 10μF) close to the Vcc pin to stabilize the supply.

2. Output Configuration:

   • The output voltage can be adjusted using external resistors if the device supports it.
   • Ensure the load current does not exceed the maximum output current of 100mA.

3. Thermal Management:

   • The thermal resistance (θJA) is 150°C/W. Ensure adequate heat dissipation, especially when operating at high currents or in high ambient temperatures.

4. Shutdown Mode:

   • To put the device into shutdown mode, pull the shutdown pin low. The shutdown current is typically 0.1μA.
   • To resume operation, bring the shutdown pin high.

5. Operating Temperature:

   • The device is designed to operate between -40°C and 85°C. Ensure the operating environment stays within these limits to avoid damage.

6. Storage Temperature:

   • Store the device in an environment where the temperature ranges from -65°C to 150°C.

7. Electrostatic Discharge (ESD) Protection:

   • Handle the device with care to prevent ESD damage. Use proper ESD protection measures during handling and installation.

8. Mounting:

   • Follow the recommended PCB layout and mounting guidelines provided by the manufacturer to ensure optimal performance and reliability.

9. Testing:

   • Before finalizing the design, test the device under various conditions to ensure it meets the required specifications.

10. Compliance:

    • Ensure the device complies with all relevant safety and regulatory standards for your application.

(For reference only)