Details

---

BUY 20LC20U https://www.utsource.net/itm/p/12611388.html

Parameter	Symbol	Min	Typical	Max	Unit	Description
Operating Voltage	VCC	2.7	-	5.5	V	Supply voltage range
Standby Current	ICC(S)	-	0.1	-	渭A	Current consumption in standby mode
Active Current	ICC(A)	-	3.0	-	mA	Current consumption in active mode
Data Retention Time	TDR	-	10	-	Years	Data retention time at 85掳C
Write Cycle Time	TWC	-	5	-	ms	Time required to complete a write cycle
Page Write Time	TPW	-	1.5	-	ms	Time required to write one page (16 bytes)
Read Access Time	TRA	-	100	-	ns	Time required to access data during read operations
Operating Temperature	Toper	-40	-	85	掳C	Operating temperature range
Storage Temperature	Tstg	-65	-	150	掳C	Storage temperature range

Instructions for 20LC20U

1. Power Supply:

   • Ensure the supply voltage (VCC) is within the specified range of 2.7V to 5.5V.
   • Connect the ground (GND) pin to a stable ground reference.

2. Data Retention:

   • The device retains data for up to 10 years at 85掳C. Store the device in a cool, dry environment to maximize data retention.

3. Write Operations:

   • A write cycle takes approximately 5 milliseconds.
   • Writing a single page (16 bytes) takes about 1.5 milliseconds.
   • Ensure that the device is not powered down or disturbed during a write cycle to avoid data corruption.

4. Read Operations:

   • The read access time is approximately 100 nanoseconds.
   • Ensure that the device is properly configured and the address lines are set correctly before initiating a read operation.

5. Operating and Storage Temperatures:

   • The device operates reliably between -40掳C and 85掳C.
   • Store the device between -65掳C and 150掳C to ensure long-term reliability.

6. Standby Mode:

   • The device consumes approximately 0.1 渭A in standby mode.
   • Use the standby mode to conserve power when the device is not in use.

7. Active Mode:

   • The device consumes approximately 3.0 mA in active mode.
   • Ensure that the power supply can handle the current requirements during active operations.

8. Handling Precautions:

   • Handle the device with care to avoid static discharge, which can damage the internal circuitry.
   • Follow proper soldering techniques and avoid excessive heat during installation.

9. Programming:

   • Refer to the device datasheet for specific programming sequences and command sets.
   • Use appropriate software tools or microcontrollers to interface with the device.

10. Pin Configuration:

    • Ensure that all pins are connected as specified in the datasheet to avoid damage or malfunction.
    • Double-check connections before applying power to the device.

(For reference only)