Details

---

BUY 2SB1565 https://www.utsource.net/itm/p/12611485.html

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Collector-Emitter Voltage	VCEO	-	-	300	V	IC = 0, TA = 25掳C
Emitter-Collector Voltage	VECS	-	-	300	V	IE = 0, TA = 25掳C
Base-Emitter Voltage	VBE	-	-	7	V	IC = 500 mA, TA = 25掳C
Base-Collector Voltage	VBCE	-	-	300	V	IC = 0, TA = 25掳C
Collector Current	IC	-	-	500	mA	VCE = 30 V, TA = 25掳C
Base Current	IB	-	-	50	mA	VCE = 30 V, TA = 25掳C
Power Dissipation	PT	-	-	125	mW	TA = 25掳C
Operating Temperature	TOP	-55	-	150	掳C	-
Storage Temperature	TSTG	-55	-	150	掳C	-

Instructions for Use:

1. Mounting:

   • Ensure proper heat sinking if operating near maximum power dissipation.
   • Use appropriate mounting hardware to secure the transistor.

2. Biasing:

   • Ensure that the base-emitter voltage (V_BE) is within the specified limits to avoid damage.
   • Use a current-limiting resistor in series with the base to prevent excessive base current (I_B).

3. Operating Conditions:

   • Do not exceed the maximum collector-emitter voltage (V_CEO) or the maximum power dissipation (P_T).
   • Operate within the specified temperature range to ensure reliable performance.

4. Handling:

   • Handle the transistor with care to avoid mechanical damage.
   • Use proper ESD (Electrostatic Discharge) precautions to prevent damage from static electricity.

5. Testing:

   • Use a multimeter to verify the continuity and resistance values before and after installation.
   • Test the transistor under controlled conditions to ensure it meets the specified parameters.

6. Storage:

   • Store the transistor in a dry, cool place away from direct sunlight and sources of heat.
   • Keep the transistor in its original packaging until ready for use to protect it from moisture and static.

7. Soldering:

   • Use a low-wattage soldering iron to avoid overheating the transistor.
   • Solder quickly to minimize thermal stress on the device.

8. Troubleshooting:

   • If the transistor fails, check for overvoltage, overcurrent, or overheating conditions.
   • Verify that all connections are secure and free from shorts or open circuits.

(For reference only)