Details

---

BUY SRD-6VDC-SL-A https://www.utsource.net/itm/p/12611508.html

Parameter	Description	Value
Model Number	Model	SRD-6VDC-SL-A
Type	Relay Type	SPDT
Coil Voltage	Operating Voltage (Coil)	6V DC
Coil Current	Operating Current (Coil)	90mA
Contact Form	Contact Configuration	SPDT
Contact Rating	Switching Capacity	10A, 250VAC
Insulation Resistance	Minimum Insulation Resistance	100M惟
Dielectric Strength	Dielectric Withstand Voltage	1500VAC
Operating Temperature	Temperature Range	-25掳C to 70掳C
Storage Temperature	Storage Temperature Range	-40掳C to 85掳C
Humidity	Relative Humidity	5% to 95%
Dimensions	Size (L x W x H)	17.5mm x 12.5mm x 12.5mm
Weight	Weight	3g
Life Expectancy	Mechanical Life	10 million cycles
Operate Time	Operate Time	10ms max
Release Time	Release Time	5ms max

Instructions:

1. Installation:

   • Ensure the relay is installed in a well-ventilated area to prevent overheating.
   • Use appropriate wiring and connectors to connect the relay to your circuit.

2. Power Supply:

   • Connect the coil terminals to a 6V DC power supply.
   • Ensure the power supply can provide at least 90mA of current to operate the relay.

3. Control Signals:

   • Apply 6V DC to the coil to energize the relay and switch the contacts.
   • Remove the voltage to de-energize the relay and return the contacts to their default position.

4. Load Connection:

   • Connect the load to the common (COM) and normally open (NO) or normally closed (NC) terminals as required.
   • Ensure the load does not exceed the contact rating of 10A at 250VAC.

5. Testing:

   • Test the relay by applying and removing the control voltage to verify proper operation.
   • Check for continuity between the COM and NO/NC terminals when the relay is energized and de-energized.

6. Maintenance:

   • Regularly inspect the relay for signs of wear or damage.
   • Replace the relay if it fails to operate correctly or if any components are damaged.

7. Safety:

   • Do not exceed the rated voltage and current limits.
   • Avoid operating the relay in environments with excessive dust, moisture, or corrosive gases.
   • Ensure the relay is properly grounded to prevent electrical hazards.

(For reference only)