Details

---

BUY LMV358AID https://www.utsource.net/itm/p/12611662.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage Range	VCC	-	2.7	-	5.5	V
Input Offset Voltage	VIO	-	-	1.0	-	mV
Input Bias Current	IB	-	-	40	-	nA
Input Voltage Noise Density	en	f = 1 kHz	-	9	-	nV/√Hz
Slew Rate	SR	-	-	0.6	-	V/μs
Bandwidth	BW	-	-	1.3	-	MHz
Output Short-Circuit	-	Continuous to either rail	-	-	-	-
Quiescent Current	IQ	Per amplifier	-	80	-	μA

Instructions for Using LMV358AID

1. Power Supply: Connect the supply voltage (V_CC) between 2.7V and 5.5V to the appropriate pins. Ensure proper decoupling capacitors are placed close to the power supply pins to reduce noise.

2. Input Signals: Apply input signals to the non-inverting (+) and inverting (-) inputs. Be cautious not to exceed the common-mode input voltage range, which is typically from GND to V_CC - 1.5V.

3. Output Configuration: The output can swing within a few millivolts of either supply rail, making it suitable for single-supply applications. For optimal performance, ensure the load resistance is within the recommended range.

4. Protection: The device has internal protection against output short circuits to either supply rail. However, avoid unnecessary stress on the device by limiting current through external components when necessary.

5. Temperature Considerations: Ensure that the operating temperature remains within the specified range to maintain performance parameters. Typically, this range is from -40°C to +125°C.

6. Layout Recommendations: Use a good PCB layout practice with short leads and proper grounding to minimize noise and interference. Place bypass capacitors close to the power supply pins.

7. Stability: To ensure stability, especially at higher frequencies, consider adding compensation components as recommended in the datasheet.

Note: Always refer to the official datasheet for the most accurate and detailed information about the LMV358AID.

(For reference only)