Details

---

BUY PIC12F508-I/P https://www.utsource.net/itm/p/12611791.html

Parameter	Description	Value
Package	Type of package	8-Pin PDIP, SOIC, MSOP
Operating Voltage (VDD)	Supply voltage range	2.0V to 5.5V
Operating Temperature Range	Temperature range for operation	-40掳C to +85掳C
Clock Frequency	Maximum clock frequency	4 MHz (internal oscillator)
Program Memory	Type and size	512 x 14-bit Flash program memory
Data Memory	Type and size	25 x 8-bit RAM registers
EEPROM	Size	64 x 8-bit EEPROM data memory
I/O Pins	Number of I/O pins	6
Timer	Type and features	Timer0 (8-bit timer/counter with prescaler)
Interrupts	Number and types	3 interrupt sources: Timer0 overflow, RB port change, External interrupt on RA5
Power-on Reset (POR)	Feature	Included
Watchdog Timer (WDT)	Feature	Optional, programmable prescaler
Low-Voltage Programming (LVP)	Feature	Not supported
Brown-out Reset (BOR)	Feature	Optional, programmable threshold
Oscillator Types	Supported types	LP, XT, HS, INTRC, EXTRC
Programming Voltage	Required voltage for programming	13.5V (external) or 4.5V to 5.5V (self-programming)

Instructions for Using PIC12F508-I/P

1. Power Supply

   • Connect VDD to the positive supply (2.0V to 5.5V).
   • Connect VSS to ground.

2. Oscillator Configuration

   • Choose the appropriate oscillator type (LP, XT, HS, INTRC, EXTRC) by setting the configuration bits.
   • For internal RC oscillator, no external components are required.
   • For external crystal or resonator, connect it between OSC1 and OSC2.

3. Programming

   • Use a PIC programmer that supports the PIC12F508.
   • Set the programming voltage (13.5V for external programming or 4.5V to 5.5V for self-programming).
   • Program the device using the hex file generated from your code.

4. Pin Configuration

   • Configure the I/O pins as inputs or outputs using TRIS registers.
   • Use the PORTA register to read or write to the I/O pins.

5. Timer0 Configuration

   • Set the T0CON register to configure the Timer0 module.
   • Enable or disable the prescaler and set its value.
   • Start the timer by setting the TMR0ON bit.

6. Interrupts

   • Enable global interrupts by setting the GIE bit in the INTCON register.
   • Enable specific interrupt sources by setting the corresponding bits in the INTCON register.
   • Write the interrupt service routine (ISR) to handle the interrupt.

7. Watchdog Timer (WDT)

   • Enable the WDT by setting the WDTE bit in the configuration word.
   • Clear the WDT periodically to prevent a reset.

8. Brown-out Reset (BOR)

   • Enable BOR by setting the BOREN bit in the configuration word.
   • Set the BOR threshold by selecting the appropriate configuration bits.

9. Low-Voltage Programming (LVP)

   • Note that LVP is not supported on the PIC12F508.

10. Reset Conditions

    • The device can be reset by:
      • Power-on reset (POR)
      • Brown-out reset (BOR)
      • Watchdog timer timeout
      • External reset on MCLR pin

11. Debugging

    • Use an in-circuit debugger to step through your code and monitor variables.
    • Ensure the MCLR pin is connected to the debugger.

12. Power Management

    • Use sleep mode to reduce power consumption by setting the SLEEP instruction.
    • Wake up from sleep using an interrupt or external signal on the MCLR pin.

(For reference only)