Details

---

BUY MC33937APEK https://www.utsource.net/itm/p/12611938.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Input Voltage	VIN	Operating	3.0	-	5.5	V
Output Voltage	VOUT	Regulated	1.2	-	5.0	V
Dropout Voltage	VDROPOUT	IOUT = 100mA	-	0.4	-	V
Quiescent Current	IQ	VIN = 5V, No Load	-	60	-	μA
Shutdown Current	ISD	VIN = 5V, SHDN Low	-	0.1	-	μA
Load Regulation	ΔVOUT/ΔILOAD	IOUT = 100mA to 500mA	-	0.5	-	%
Line Regulation	ΔVOUT/ΔVIN	VIN = 3V to 5.5V	-	0.1	-	%
Ripple Rejection	RR	120Hz	-	70	-	dB
Operating Junction Temperature	TJOP	Continuous	-40	-	125	°C

Instructions for MC33937APEK:

1. Power Supply Connection:

   • Connect the input voltage (VIN) within the specified range of 3.0V to 5.5V.
   • Ensure a stable power supply to avoid fluctuations.

2. Output Configuration:

   • Set the output voltage (VOUT) as required between 1.2V and 5.0V using external resistors or preset configurations.
   • Verify the output voltage with a multimeter before connecting any load.

3. Grounding:

   • Ensure a common ground connection between the input, output, and any external circuits.

4. Capacitors:

   • Place an input capacitor (typically 1μF ceramic) close to the VIN pin.
   • Use an output capacitor (typically 1μF ceramic) near the VOUT pin to stabilize the output.

5. Shutdown Feature:

   • To disable the regulator, pull the shutdown pin (SHDN) low. This reduces the current consumption significantly.
   • For normal operation, keep the SHDN pin high or floating.

6. Thermal Considerations:

   • Operate within the junction temperature range (-40°C to 125°C).
   • If operating at higher currents or in high ambient temperatures, ensure adequate heat dissipation.

7. PCB Layout:

   • Keep traces short and wide for power and ground connections to minimize inductance and resistance.
   • Ensure proper thermal vias are placed under the IC for efficient heat transfer.

8. Handling:

   • Handle with care to prevent electrostatic discharge (ESD) damage.
   • Follow standard anti-static precautions during assembly and handling.

(For reference only)