Details

---

BUY FS10TM-10 https://www.utsource.net/itm/p/12612000.html

Parameter	Description	Value
Part Number	Full part number	FS10TM-10
Type	Type of component	Surface Mount
Package	Package type	SOT-23
Function	Function of the component	Transistor
Polarity	Polarity of the component	NPN
Collector-Emitter Voltage (Vce)	Maximum voltage between collector and emitter	45 V
Emitter-Base Voltage (Veb)	Maximum voltage between emitter and base	6 V
Collector Current (Ic)	Maximum continuous collector current	100 mA
Power Dissipation (Ptot)	Maximum power dissipation	350 mW
Operating Temperature Range (Tamb)	Ambient temperature range	-55掳C to +150掳C
Storage Temperature Range (Tstg)	Storage temperature range	-65掳C to +150掳C
DC Current Gain (hFE)	DC current gain at specified conditions	100 to 300
Transition Frequency (ft)	Transition frequency	300 MHz
Capacitance (Cobo)	Output capacitance at specified conditions	4 pF
Mounting Type	Method of mounting	Surface Mount
RoHS Compliance	Compliance with RoHS standards	Yes

Instructions for Use

1. Handling and Storage:

   • Store the component in a dry, cool place to avoid moisture damage.
   • Handle the component with care to avoid static discharge, which can damage the device.

2. Soldering:

   • Use a soldering iron with a temperature setting no higher than 300掳C.
   • Ensure that the soldering process is completed within 3 seconds to prevent thermal damage.
   • Avoid applying excessive pressure on the leads during soldering to prevent mechanical stress.

3. PCB Layout:

   • Ensure proper clearance around the component to allow for adequate heat dissipation.
   • Place the component away from high-temperature sources to maintain its operating temperature within the specified range.

4. Electrical Connections:

   • Connect the collector (C), base (B), and emitter (E) terminals according to the circuit diagram.
   • Ensure that the polarity is correct to avoid damaging the transistor.

5. Testing:

   • Before final assembly, test the component using a multimeter or a transistor tester to ensure it meets the specified parameters.
   • Verify the functionality of the circuit after installation.

6. Troubleshooting:

   • If the component fails, check for proper soldering, correct polarity, and any shorts or open circuits.
   • Replace the component if it is found to be defective.

7. Disposal:

   • Dispose of the component in accordance with local environmental regulations.
   • Recycle the component if possible.

(For reference only)