Details

---

BUY AF9592 https://www.utsource.net/itm/p/12612077.html

Parameter	Description	Min	Typ	Max	Unit
Supply Voltage (VDD)	Operating supply voltage range	1.7	-	3.6	V
Standby Current (ISB)	Current consumption in standby mode	-	0.1	-	渭A
Active Current (IACT)	Current consumption in active mode	-	3.0	-	mA
Input Voltage Range (VIN)	Range of input signal voltage	0	-	VDD	V
Output Voltage Swing (VOUT)	Output voltage swing range	0	-	VDD - 0.2	V
Input Impedance (ZIN)	Input impedance	-	10	-	M惟
Bandwidth (BW)	Frequency range over which gain is flat within 3 dB	-	10	-	MHz
Slew Rate (SR)	Maximum rate of change of output voltage	-	1.5	-	V/渭s
Power-down Time (tPD)	Time to enter power-down mode	-	1	-	渭s
Wake-up Time (tWU)	Time to exit power-down mode	-	1	-	渭s
Operating Temperature (Toper)	Temperature range for operation	-40	-	85	掳C
Storage Temperature (Tstg)	Temperature range for storage	-65	-	150	掳C

Instructions for Using AF9592

1. Power Supply:

   • Connect the VDD pin to a stable power supply within the range of 1.7V to 3.6V.
   • Ensure the ground (GND) pin is connected to the system ground.

2. Input Signal:

   • Apply the input signal to the VIN pin. The input voltage should be within the range of 0V to VDD.
   • The input impedance is 10M惟, so ensure the source impedance is compatible to avoid loading issues.

3. Output Signal:

   • The output signal will be available on the VOUT pin. The output voltage swing is from 0V to VDD - 0.2V.
   • Ensure the load impedance is appropriate for the desired output level.

4. Power Management:

   • To enter power-down mode, set the power-down control pin (PD) to a high state.
   • To wake up from power-down mode, set the PD pin to a low state.
   • The power-down time (tPD) is approximately 1渭s, and the wake-up time (tWU) is also approximately 1渭s.

5. Temperature Considerations:

   • The device operates reliably within the temperature range of -40掳C to 85掳C.
   • Store the device in a temperature range of -65掳C to 150掳C to ensure long-term reliability.

6. Handling and Storage:

   • Handle the device with care to avoid static damage.
   • Store the device in a dry, cool place to prevent moisture-related issues.

7. Testing and Verification:

   • Before finalizing the design, perform thorough testing under various operating conditions to ensure the device meets the required specifications.
   • Use a multimeter or oscilloscope to verify the input and output signals, and check the current consumption in both active and standby modes.

(For reference only)