Details

---

BUY TS922AID https://www.utsource.net/itm/p/12612142.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Operating	4.5	5	5.5	V
Input Voltage	VI	Relative to GND	-0.3		VCC+0.3	V
Output Voltage	VO	High Level		VCC-1.7	VCC-0.4	V
		Low Level	0		0.4	V
Output Current	IO	Sink		10	25	mA
		Source		1	5	mA
Input Current	II	High Level	-1	-0.1		μA
		Low Level	1	0.1		μA
Propagation Delay	tpd	VCC=5V, VI=VCC/2	10	20	30	ns

Instructions for TS922AID

1. Supply Voltage (V_CC):

   • Ensure the supply voltage is within the range of 4.5V to 5.5V.
   • Use a stable power source to avoid fluctuations that could affect performance.

2. Input Voltage (V_I):

   • The input voltage should not exceed the supply voltage by more than 0.3V and should not be less than -0.3V relative to ground.
   • Ensure the input signals are within these limits to prevent damage to the device.

3. Output Voltage (V_O):

   • The output high level should be between V_CC-1.7V and V_CC-0.4V.
   • The output low level should be between 0V and 0.4V.
   • These levels ensure proper logic levels for interfacing with other digital circuits.

4. Output Current (I_O):

   • The device can sink up to 25mA and source up to 5mA.
   • Ensure the load connected to the output does not exceed these current ratings to avoid damage.

5. Input Current (I_I):

   • The input current at high level should be between -1μA and -0.1μA.
   • The input current at low level should be between 1μA and 0.1μA.
   • These values help in determining the pull-up or pull-down resistors needed for the input lines.

6. Propagation Delay (t_pd):

   • The propagation delay is the time it takes for the output to change state after the input changes.
   • At V_CC = 5V and V_I = V_CC/2, the typical delay is 20ns with a maximum of 30ns.
   • This parameter is crucial for timing considerations in your circuit design.

7. Handling and Storage:

   • Handle the device with care to avoid static damage.
   • Store in a dry, cool place away from direct sunlight and moisture.

8. Mounting:

   • Follow standard surface mount technology (SMT) procedures for mounting the device on the PCB.
   • Ensure proper soldering to avoid cold joints and ensure reliable connections.

By adhering to these parameters and instructions, you can ensure optimal performance and reliability of the TS922AID in your application.

(For reference only)