Details

---

BUY AD7367BRUZ https://www.utsource.net/itm/p/12612281.html

Parameter	Symbol	Conditions	Min	Typical	Max	Unit
Supply Voltage	VDD	Operating Range	2.7	-	5.25	V
Supply Current (Active)	IDD	VDD = 5V	-	2.0	-	mA
Supply Current (Power-Down)	IDD	VDD = 5V	-	10	-	μA
Input Voltage Range	VIN	VDD = 5V	0	-	VDD	V
Output Voltage Range	VOUT	VDD = 5V	0	-	VDD	V
Conversion Time	tCONV	Single Channel	-	20	-	μs
Power-Down Time	tPD		-	5	-	μs
Output Data Rate	fODR		-	100	-	kSPS
Differential Nonlinearity	DNL		-1	0	+1	LSB
Integral Nonlinearity	INL		-1	0	+1	LSB
Offset Error	VOS	VDD = 5V	-	2	-	mV
Gain Error	GAIN	VDD = 5V	-	0.1	-	% FS
Temperature Range	Toper	Operating Range	-40	-	125	°C

Instructions for Using AD7367BRUZ

1. Power Supply:

   • Connect the supply voltage (VDD) to a stable power source within the operating range of 2.7V to 5.25V.
   • Ensure the ground (GND) is properly connected.

2. Input Configuration:

   • Connect the analog input signals to the VIN pins.
   • The input voltage should be within the range of 0V to VDD.

3. Output Configuration:

   • The output voltage (VOUT) will be proportional to the input voltage.
   • Ensure the output is connected to the appropriate load or next stage in your circuit.

4. Power-Down Mode:

   • To enter power-down mode, set the appropriate control signal (e.g., PDN pin) to a high state.
   • The device will enter a low-power state with minimal current consumption.

5. Conversion and Data Rate:

   • The conversion time is approximately 20 μs for a single channel.
   • Set the output data rate (fODR) according to your application requirements, up to 100 kSPS.

6. Calibration:

   • Perform any necessary calibration to correct for offset and gain errors.
   • Use the provided DNL and INL specifications to ensure accurate conversions.

7. Temperature Considerations:

   • The device operates over a temperature range of -40°C to 125°C.
   • Monitor the temperature to ensure it remains within the specified limits.

8. Handling and Storage:

   • Handle the device with care to avoid damage from electrostatic discharge (ESD).
   • Store the device in a dry, cool environment when not in use.

(For reference only)