Details

---

BUY DSPIC30F6011A-30I/PT https://www.utsource.net/itm/p/12612481.html

Parameter	Description	Value
Device	Microcontroller	dsPIC30F6011A
Package	Package Type	44-Pin TQFP (PT)
Operating Voltage (Vdd)	Supply Voltage Range	2.8 V to 5.5 V
Operating Temperature	Temperature Range	-40掳C to +85掳C
Clock Frequency	Maximum Internal Clock Speed	30 MHz
Flash Memory	Program Memory Size	128 KB
RAM	Data Memory Size	8 KB
EEPROM	EEPROM Size	2 KB
ADC	Analog-to-Digital Converter Channels	12-bit, 16 channels
DAC	Digital-to-Analog Converter Channels	2 x 10-bit
Timers	Number of Timers/PWM Channels	5 x 16-bit timers
Comparators	Number of Comparators	4
Communication Interfaces	Supported Communication Protocols	I2C, SPI, UART
Interrupts	Number of Interrupt Sources	49
Pin Count	Total Number of Pins	44
Power Consumption	Active Mode Power Consumption (Typical at 30 MHz, 3.3 V)	27 mA
Low-Power Modes	Sleep Mode Power Consumption (Typical at 3.3 V)	0.5 渭A

Instructions for Using dsPIC30F6011A-30I/PT

1. Power Supply:

   • Connect the Vdd pin to a power supply within the range of 2.8 V to 5.5 V.
   • Connect the Vss pin to ground.

2. Clock Configuration:

   • Use the internal oscillator or an external crystal/clock source to set the clock frequency.
   • Configure the clock settings using the device configuration bits.

3. Programming:

   • Use a programmer compatible with dsPIC devices, such as MPLAB ICD 3 or PICkit 3.
   • Write your code in C or assembly using MPLAB X IDE.
   • Program the device using the ICSP (In-Circuit Serial Programming) interface.

4. Configuration Bits:

   • Set the configuration bits to define device-specific parameters such as oscillator type, watchdog timer, and brown-out reset.
   • Example configuration bits include FOSC, FWDTEN, and FBORPOR.

5. Peripheral Initialization:

   • Initialize the ADC, DAC, timers, and communication interfaces in your code.
   • Configure the desired settings for each peripheral.

6. Interrupt Handling:

   • Enable interrupts by setting the appropriate bits in the INTCON register.
   • Write interrupt service routines (ISRs) to handle specific interrupt sources.

7. Low-Power Modes:

   • Enter sleep mode by setting the SLEEP bit in the SLEEP register.
   • Use the watchdog timer to wake up from sleep mode if needed.

8. Debugging:

   • Use the debugger feature in MPLAB X IDE to step through your code and monitor variables.
   • Utilize breakpoints and watchpoints to identify and fix issues.

9. Datasheet and Reference Manual:

   • Refer to the dsPIC30F6011A datasheet and reference manual for detailed information on registers, timing diagrams, and advanced features.

By following these instructions, you can effectively use the dsPIC30F6011A-30I/PT microcontroller in your projects.

(For reference only)