Details

---

BUY KSC2682Y https://www.utsource.net/itm/p/12614393.html

Parameter	Description	Value
Part Number	Full part number	KSC2682Y
Type	Type of component	Schottky Diode
Package	Package type	SOD-123
Forward Voltage	Maximum forward voltage (VF) at IF	0.45V @ 1A
Reverse Voltage	Maximum reverse voltage (VR)	40V
Average Rectified Current	IAV at TA = 25掳C	2A
Peak Forward Surge Current	IFSM (10ms single pulse)	80A
Operating Temperature Range	TA	-65掳C to +175掳C
Storage Temperature Range	TSTG	-65掳C to +175掳C
Thermal Resistance	Junction to Ambient (R胃JA)	150掳C/W
Capacitance	Reverse recovery capacitance (CR) at VR	45pF @ 1MHz
Reverse Recovery Time	trr	25ns

Instructions for Use:

1. Mounting:

   • Ensure the diode is mounted on a PCB with adequate thermal management.
   • Use a heat sink if the diode will be operating near its maximum current or temperature ratings.

2. Soldering:

   • Preheat the PCB to reduce thermal shock.
   • Use a soldering iron with a tip temperature of 350掳C 卤 50掳C.
   • Complete soldering within 3 seconds to avoid overheating the diode.

3. Handling:

   • Handle the diode with care to avoid mechanical stress.
   • Avoid touching the leads directly; use tweezers or a vacuum pickup tool.

4. Electrical Connections:

   • Connect the cathode (K) to the positive side of the circuit.
   • Connect the anode (A) to the negative side of the circuit.
   • Ensure the reverse voltage does not exceed 40V to prevent breakdown.

5. Testing:

   • Test the diode using a multimeter set to diode test mode.
   • The forward voltage should be around 0.45V when measured from anode to cathode.
   • The reverse resistance should be very high when measured from cathode to anode.

6. Storage:

   • Store the diode in a dry, cool place away from direct sunlight.
   • Keep the diode in its original packaging until ready for use to protect against static discharge.

7. Safety:

   • Always follow proper safety guidelines when handling electronic components.
   • Wear appropriate personal protective equipment (PPE) when soldering or handling the diode.

(For reference only)