Details

---

BUY SW-602B-P https://www.utsource.net/itm/p/12614821.html

Parameter	Description
Model Number	SW-602B-P
Type	Reed Switch
Contact Form	SPST-NO (Single Pole, Single Throw - Normally Open)
Rated Voltage	240V AC / 30V DC
Rated Current	1A (resistive load)
Maximum Switching Power	60W (AC/DC)
Contact Resistance	< 50 m惟 (initial)
Insulation Resistance	> 100 M惟 (at 500V DC)
Dielectric Strength	1000V AC (1 minute)
Operating Temperature	-40掳C to +85掳C
Storage Temperature	-40掳C to +125掳C
Magnetic Sensitivity	10-150 A/m (depending on orientation)
Operate Time	< 1 ms (typical)
Release Time	< 1 ms (typical)
Mechanical Life	> 10 million operations
Electrical Life	> 100,000 operations (at rated load)
Material	Glass encapsulated, nickel-plated copper alloy contacts
Dimensions	12.7 mm (L) x 5.08 mm (D)
Weight	0.2 g

Instructions for Use

1. Installation:

   • Ensure the switch is installed in a clean, dry environment.
   • Handle the switch with care to avoid damaging the glass encapsulation.
   • Mount the switch in a position where it will not be subjected to excessive mechanical stress.

2. Wiring:

   • Connect the switch to your circuit according to the contact form (SPST-NO).
   • Ensure that the voltage and current ratings of the switch are not exceeded.
   • Use appropriate wire gauge to handle the current flowing through the switch.

3. Operation:

   • The switch operates when a magnetic field of sufficient strength is brought close to it.
   • The magnetic sensitivity can vary depending on the orientation of the switch relative to the magnet.
   • Test the operation of the switch by bringing a magnet close to it and observing the contact closure.

4. Maintenance:

   • Regularly inspect the switch for any signs of damage or wear.
   • Clean the switch with a soft, dry cloth if necessary.
   • Do not use abrasive materials or solvents that could damage the glass encapsulation.

5. Storage:

   • Store the switch in a cool, dry place away from direct sunlight and sources of heat.
   • Avoid storing the switch in environments with high humidity or corrosive gases.

6. Disposal:

   • Dispose of the switch in accordance with local environmental regulations.
   • Do not incinerate the switch as it may release harmful substances.

(For reference only)