Details

---

BUY 2SA1477S https://www.utsource.net/itm/p/12614828.html

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Collector-Emitter Voltage	VCE	-	-	60	V	-
Emitter-Base Voltage	VEB	-5.0	-	-	V	-
Collector Current	IC	-	-	8.0	A	-
Base Current	IB	-	-	0.8	A	-
Power Dissipation	PT	-	-	125	W	TA = 25掳C
Junction Temperature	TJ	-	-	150	掳C	-
Storage Temperature	TSTG	-55	-	150	掳C	-
Thermal Resistance	R胃JC	-	1.2	-	掳C/W	Case to Junction
Forward Current Transfer Ratio	hFE	20	70	150	-	IC = 150mA, VCE = 5V

Instructions for Use:

1. Handling Precautions:

   • Handle the 2SA1477S with care to avoid mechanical damage.
   • Use proper ESD (Electrostatic Discharge) protection when handling the device.

2. Mounting:

   • Ensure that the mounting surface is clean and flat.
   • Apply thermal compound between the transistor and the heat sink to improve thermal conductivity.
   • Tighten the mounting screws to the recommended torque to avoid damaging the transistor.

3. Operating Conditions:

   • Do not exceed the maximum ratings specified in the table.
   • Ensure adequate cooling to keep the junction temperature within safe limits, especially under high power dissipation conditions.

4. Testing:

   • Use a multimeter or a transistor tester to check the continuity and forward voltage drop across the base-emitter and base-collector junctions.
   • Measure the h_FE (current gain) to ensure it falls within the typical range.

5. Storage:

   • Store the 2SA1477S in a dry, cool place away from direct sunlight.
   • Keep the devices in their original packaging until ready for use to protect against static discharge.

6. Soldering:

   • Use a soldering iron with a temperature-controlled tip.
   • Avoid overheating the leads during soldering; the maximum soldering time should not exceed 10 seconds at a temperature of 300掳C.

7. Circuit Design:

   • Ensure that the circuit design accounts for the maximum current and voltage ratings.
   • Use appropriate resistors to limit the base current and protect the transistor from excessive current.

8. Safety:

   • Always follow safety guidelines when working with electrical circuits.
   • Disconnect the power supply before making any changes to the circuit.

(For reference only)