Details

---

BUY MAX3243EEAI+ https://www.utsource.net/itm/p/12622696.html

Parameter	Description	Min	Typ	Max	Unit
Supply Voltage (VCC)	Operating supply voltage range	2.7	-	5.5	V
Supply Current (ICC)	Supply current per channel	-	100	-	μA
Input Offset Voltage	Maximum input offset voltage	-	1.5	-	mV
Input Bias Current	Maximum input bias current	-	1	-	nA
Slew Rate	Slew rate	-	0.6	-	V/μs
Output Short-Circuit Duration	Output short-circuit duration	-	Unlimited	-	s
Common-Mode Input Voltage Range	Common-mode input voltage range	-0.3	-	VCC+0.3	V
Differential Input Voltage	Maximum differential input voltage	±35	-	-	V
Operating Temperature Range	Device operating temperature range	-40	-	85	°C

Instructions for Use:

1. Power Supply Connections:

   • Connect the VCC pin to a power supply within the specified range of 2.7V to 5.5V.
   • Ensure the GND pin is connected to the system ground.

2. Signal Connections:

   • Connect the input signals to the appropriate IN+ and IN- pins.
   • Connect the output to the required load or next stage circuitry via the OUT pin.

3. Handling Static Electricity:

   • The MAX3243EEAI+ is sensitive to static electricity; use proper anti-static precautions when handling.

4. Operating Temperature:

   • Ensure the device operates within the specified temperature range of -40°C to +85°C to avoid damage.

5. Short Circuit Protection:

   • The device has built-in protection for output short circuits, but it is advisable to design the surrounding circuitry to minimize the risk of shorts.

6. Input Voltage Limits:

   • Do not exceed the common-mode input voltage range to prevent damage to the device. Inputs should be within VCC+0.3V and -0.3V relative to ground.

7. Differential Input Voltage:

   • Keep the differential input voltage within ±35V to ensure reliable operation and prevent damage.

8. Decoupling Capacitors:

   • Place decoupling capacitors close to the VCC and GND pins to stabilize the power supply and reduce noise. A typical value is 0.1μF.

9. Slew Rate Consideration:

   • Be aware of the slew rate limitation (0.6V/μs) when designing signal paths that require fast switching times.

(For reference only)