Details

---

BUY HD6413003F10 https://www.utsource.net/itm/p/451474.html
MCU AVR 32KB FLASH 40PDIP

Parameter	Description	Value
Product Name	High-Density CMOS Microcontroller	HD6413003F10
Package Type	QFP (Quad Flat Package)	100-Pin
Operating Voltage	Supply Voltage Range	2.7V to 5.5V
Operating Temperature	Industrial Temperature Range	-40掳C to +85掳C
CPU Core	Core Type	Hitachi H8S/2000
Clock Frequency	Maximum Clock Speed	16 MHz
Flash Memory	On-Chip Flash Memory Size	32 KB
RAM	On-Chip RAM Size	2 KB
Data Bus Width	Internal Data Bus Width	16-bit
Address Bus Width	Internal Address Bus Width	16-bit
I/O Ports	Number of General Purpose I/O Pins	64
Timers	Number of Timers	3
Communication Interfaces	Available Communication Interfaces	UART, SPI, I2C
ADC Channels	Analog-to-Digital Converter Channels	8 channels, 10-bit
Watchdog Timer	Integrated Watchdog Timer	Yes
Power Management	Low Power Modes	Sleep, Stop

Instructions for Use:

1. Power Supply: Ensure the supply voltage is within the specified range of 2.7V to 5.5V. Connect the VCC and GND pins appropriately.
2. Clock Configuration: Configure the external crystal or oscillator connected to the XTAL1 and XTAL2 pins if not using an internal clock source.
3. Reset Pin: The RESET pin should be pulled high to initialize the microcontroller properly. It can also be used to reset the device during operation.
4. Programming Interface: Use the SWD or JTAG interface for programming and debugging purposes. Refer to the datasheet for specific pin configurations.
5. I/O Handling: Configure the GPIO pins as inputs or outputs according to your application needs using the appropriate registers.
6. Peripheral Setup: Initialize timers, ADC, communication interfaces (UART, SPI, I2C), and other peripherals by configuring their respective control registers.
7. Interrupts: Set up interrupt vectors and enable interrupts for events like timer overflows, serial data reception, etc.
8. Low Power Modes: Utilize sleep and stop modes to reduce power consumption when the microcontroller is idle. Manage these modes through software control.
9. Software Development: Use a compatible IDE and compiler that supports the H8S/2000 architecture for writing and compiling code.

For detailed register maps, timing diagrams, and advanced configuration options, refer to the official HD6413003F10 datasheet and technical documentation.

(For reference only)