Details

---

BUY MC33072ADR2 https://www.utsource.net/itm/p/546019.html
High Slew Rate, Wide Bandwidth, Single Supply Operational Amplifiers

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	Vcc	Operating	2.0		36.0	V
Input Offset Voltage	Vio		-5	0	5	mV
Input Bias Current	Iib		-100	0	100	nA
Input Offset Current	Iios		-10	0	10	nA
Open Loop Gain (Large Signal)	Aol	Vout = 1Vpp	70			dB
Slew Rate	SR		0.4			V/渭s
Output Short-Circuit Duration	tsc	Continuous				ms
Quiescent Current	IQ		20			渭A
Common-Mode Rejection Ratio	CMRR		80			dB
Power Supply Rejection Ratio	PSRR		80			dB
Operating Temperature Range	Topr	Storage	-40		125	掳C

Instructions for MC33072ADR2

1. Supply Voltage: Ensure the supply voltage is within the operating range of 2.0V to 36.0V. Exceeding this range can damage the device.

2. Input Signals: Keep input signals within the common-mode input voltage range to avoid distortion or damage. The input bias and offset currents should be considered when designing input circuits.

3. Output Load: Ensure the output load does not cause the output current to exceed safe levels, which could lead to overheating or damage.

4. Powering Up: Apply power carefully, ensuring that the power supply rise time is adequate to prevent latch-up conditions.

5. Thermal Considerations: Operate within the specified temperature range (-40掳C to 125掳C). For extended operation in high-temperature environments, ensure adequate heat dissipation.

6. Short Circuit Protection: While the device has some level of short-circuit protection, it is recommended to limit the duration of short circuits to avoid potential damage.

7. Decoupling Capacitors: Use appropriate decoupling capacitors close to the power supply pins to minimize noise and transient effects.

8. Layout Considerations: Follow good PCB layout practices to minimize parasitic inductances and capacitances, especially for high-frequency applications.

9. Storage and Handling: Store and handle the device in accordance with anti-static guidelines to prevent ESD damage.

(For reference only)