Details

---

BUY BTA16-800 https://www.utsource.net/itm/p/1901136.html
STANDARD TRIACS

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Repetitive Peak Off-State Voltage	VDRM	Tj = 25°C	-	800	-	V
Repetitive Peak Reverse Voltage	VRRM	Tj = 25°C	-	800	-	V
RMS On-State Current	IT(RMS)	Tj ≤ 100°C	-	16	-	A
Non-Repetitive Peak On-State Current	ITSM	Pulse Width ≤ 10ms, Duty Cycle ≤ 2%	-	150	-	A
Holding Current	IH	Tj = 25°C	30	-	-	mA
Gate Trigger Current	IG(T)	Tj = 25°C	5	-	50	mA
Gate Trigger Voltage	VG(T)	Tj = 25°C	1.5	-	3	V
Maximum Junction Temperature	Tj(max)	-	-	-	125	°C

Instructions for BTA16-800

1. Mounting and Handling:

   • Ensure the device is mounted on a heatsink if continuous operation near maximum current ratings is expected.
   • Handle with care to avoid damage to the sensitive gate terminal.

2. Operating Conditions:

   • Do not exceed the maximum junction temperature of 125°C.
   • Keep within the specified voltage and current limits to prevent damage or premature failure.

3. Triggering:

   • Apply a gate trigger current (IG(T)) between 5mA and 50mA at a gate trigger voltage (VG(T)) ranging from 1.5V to 3V.
   • Ensure the holding current (IH) exceeds 30mA to maintain conduction after triggering.

4. Current Ratings:

   • The RMS on-state current (IT(RMS)) should not exceed 16A continuously.
   • For short pulses, the non-repetitive peak on-state current (ITSM) can reach up to 150A under specified conditions.

5. Voltage Ratings:

   • Both repetitive peak off-state voltage (VDRM) and repetitive peak reverse voltage (VRRM) are rated at 800V; ensure that these ratings are not exceeded in the circuit design.

6. Safety Precautions:

   • Always use appropriate safety measures when handling high voltages and currents.
   • Ensure proper insulation and protection against electrical hazards.

(For reference only)