Details

---

BUY LT1112S8#TRPBF https://www.utsource.net/itm/p/4790176.html
IC OPAMP GP 2 CIRCUIT 8SO

Parameter	Min	Typ	Max	Unit	Description
Input Voltage (V IN)	2.7		5.5	V	Operating input voltage range
Output Voltage (V OUT)		3.3		V	Fixed output voltage
Quiescent Current		60		渭A	Supply current in regulation
Dropout Voltage		180		mV	Dropout voltage at full load
Load Regulation		0.5		%	Change in output voltage over load range
Line Regulation		0.01		%/V	Change in output voltage over input voltage range
Power Supply Rejection Ratio (PSRR)	70		90	dB	Attenuation of ripple from input to output
Thermal Shutdown		160		掳C	Temperature at which device shuts down
Short-Circuit Protection	Yes				Protection against short circuit

Instructions for Use:

1. Input Voltage Connection: Connect the input voltage between VIN and GND. Ensure the input voltage is within the specified range of 2.7V to 5.5V.
2. Output Voltage Connection: The output voltage is fixed at 3.3V. Connect your load between VOUT and GND.
3. Bypass Capacitors: It is recommended to place a 1渭F ceramic capacitor from VIN to GND and another from VOUT to GND to ensure stability.
4. Thermal Considerations: The device includes thermal shutdown protection, but ensure adequate heat dissipation if operating near the maximum input voltage or under heavy loads.
5. Short-Circuit Protection: The device is equipped with short-circuit protection, but avoid prolonged short circuits to prevent potential damage.
6. Layout Recommendations: Keep the PCB layout compact, especially for bypass capacitors, to minimize noise and improve performance.

Note: Always refer to the latest datasheet from the manufacturer for the most accurate and detailed information.

(For reference only)