Details

---

BUY RDA5807FP https://www.utsource.net/itm/p/5041042.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	VDD	2.7		3.6	V	Operating supply voltage range
Standby Current	ISB		0.5		μA	Average current in standby mode
Active Current	IOP		14		mA	Average current in active mode
Frequency Range	fRX	76		108	MHz	FM receiver frequency range
Tuning Step	Δf		0.1		MHz	Frequency tuning step size
Signal-to-Noise Ratio	SNR		55		dB	Signal-to-noise ratio at typical operating conditions
Sensitivity	S		-98		dBμV	Sensitivity level for a 10dB signal-to-noise ratio
Image Rejection	IMRJ		70		dB	Image rejection ratio
Adjacent Channel Rej.	ACRJ		70		dB	Adjacent channel rejection ratio
Stereo Mono Switch Time	TSM		10		ms	Time to switch between stereo and mono modes

Instructions for RDA5807FP

1. Power Supply Connection:

   • Connect the VDD pin to a stable power supply within the specified voltage range (2.7V to 3.6V).
   • Ensure that the power supply has adequate decoupling capacitors to reduce noise.

2. Frequency Tuning:

   • Use the serial interface (I2C) to set the desired frequency within the 76MHz to 108MHz range.
   • The tuning step is 0.1MHz, allowing precise frequency selection.

3. Mode Selection:

   • Choose between stereo and mono modes using the appropriate command via the I2C interface.
   • Monitor the stereo-mono status if necessary, especially during weak signal reception.

4. Signal Strength and Quality Monitoring:

   • Utilize the built-in signal strength and quality indicators to optimize reception.
   • Adjust antenna or position as needed based on these readings.

5. Standby Mode:

   • To conserve power, put the device into standby mode when not actively receiving signals.
   • In standby mode, the device consumes significantly less current.

6. Initialization and Configuration:

   • Upon power-up, initialize the device using the I2C interface with default settings or customize according to application needs.
   • Refer to the datasheet for detailed initialization sequences and register configurations.

7. Interference Mitigation:

   • Ensure proper shielding and grounding to minimize external interference.
   • Utilize the image rejection and adjacent channel rejection features to maintain signal integrity.

8. Software Considerations:

   • Implement software routines to handle I2C communication, error checking, and state management.
   • Provide user feedback for tuning and signal quality through an interface or display.

Note: Always refer to the latest datasheet provided by the manufacturer for the most accurate and detailed information regarding the RDA5807FP.

(For reference only)