Details

---

BUY PIC16F1824-I/SL https://www.utsource.net/itm/p/5538800.html
14/20-Pin Flash Microcontrollers with nanoWatt XLP Technology

Parameter	Description	Value
Package	Type	SOIC
Operating Voltage (Vdd)	Range	2.0V to 5.5V
Operating Temperature	Range	-40掳C to +85掳C
Flash Program Memory	Size	2K x 14
EEPROM Data Memory	Size	128 x 8
RAM Data Memory	Size	256 x 8
Oscillator	Types Supported	LP, XT, HS, INTRC, EC
I/O Pins	Count	18
Timer1	Features	16-bit timer/counter with prescaler
Timer2	Features	8-bit timer/counter with prescaler and postscaler
Comparator Modules	Count	2
Analog-to-Digital Converter (ADC)	Channels	9 channels, 10-bit resolution
Universal Synchronous Asynchronous Receiver Transmitter (USART)	Features	1, Full-duplex asynchronous or synchronous mode
Master Synchronous Serial Port (MSSP)	Features	Supports SPI/I2C protocols
Capture/Compare/PWM (CCP)	Features	2 modules, PWM output
Brown-out Reset (BOR)	Feature	Yes
Low-Voltage Programming (LVP)	Feature	Yes

Instructions for Use:

1. Power Supply Setup:

   • Connect Vdd to a stable power supply within the operating voltage range of 2.0V to 5.5V.
   • Ensure Vss is connected to ground.

2. Oscillator Configuration:

   • Select an appropriate oscillator type (LP, XT, HS, INTRC, EC) based on application requirements.
   • Configure the OSCCON register as needed for internal oscillator settings.

3. Memory Initialization:

   • Initialize Flash program memory, EEPROM data memory, and RAM according to your application needs.
   • Use MPLAB X IDE or similar software for programming.

4. Peripheral Setup:

   • Configure peripherals such as Timer1, Timer2, ADC, USART, MSSP, and CCP modules using respective control registers.
   • Refer to the datasheet for specific register configurations.

5. Interrupt Management:

   • Set up interrupt priorities and enable/disable interrupts as required by configuring INTCON and PIE registers.

6. Low Power Modes:

   • Utilize sleep modes to reduce power consumption when the microcontroller is idle.
   • Wake-up sources can be configured via WDT, pin change, or external interrupts.

7. Programming and Debugging:

   • Use MPLAB XC8 compiler for writing code.
   • Employ PICkit 3 or other compatible programmers/debuggers for downloading code and debugging.

8. Safety Considerations:

   • Always adhere to maximum ratings and ensure proper decoupling capacitors are used near power pins.
   • Implement reset circuits if necessary to handle unexpected conditions.

(For reference only)