Details

---

BUY LM2576T12 https://www.utsource.net/itm/p/6487727.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Input Voltage	VIN	4.5	-	40	V	Operating input voltage range
Output Voltage	VOUT	-	12	-	V	Fixed output voltage
Output Current	IOUT	-	3	-	A	Maximum continuous output current
Switching Frequency	fSW	-	52	-	kHz	Internal oscillator frequency
Dropout Voltage	VDROPOUT	-	1.7	-	V	Dropout voltage at 3A output
Quiescent Current	IQ	-	5	-	mA	Quiescent current
Efficiency	畏	-	80	-	%	Typical efficiency
Line Regulation	未VLINE	-	0.1	-	%/V	Line regulation
Load Regulation	未VLOAD	-	0.1	-	%/A	Load regulation
Transient Response	-	-	-	-	-	Performance under transient conditions
Operating Temperature	Toper	-40	-	125	掳C	Operating temperature range
Storage Temperature	Tstg	-65	-	150	掳C	Storage temperature range

Instructions for Use:

1. Input Capacitor Selection: Choose an input capacitor with a low ESR to ensure stability and minimize ripple. A ceramic or tantalum capacitor is recommended.

2. Output Capacitor Selection: Select an output capacitor based on the desired output ripple. Larger capacitance reduces ripple but may increase response time to load changes.

3. Inductor Selection: The inductor value should be chosen based on the desired balance between output ripple and efficiency. Typically, values between 10渭H and 100渭H are used.

4. Bypass Capacitors: Place bypass capacitors as close as possible to the input and output pins of the LM2576T-12 to reduce noise and improve transient response.

5. Heat Dissipation: Ensure adequate heat sinking if operating near maximum output current to maintain component reliability.

6. Layout Considerations: Keep the layout compact and use wide traces for power paths to minimize resistance and inductance, improving performance and reliability.

7. Protection Diode: Use a Schottky diode for the freewheeling path; it should have a reverse voltage rating higher than the maximum input voltage and a forward current rating greater than the maximum output current.

8. Stability: For stable operation, ensure that the external components (capacitors, inductors) are within the recommended ranges provided in the datasheet.

9. Testing: Before finalizing the design, test the circuit under various conditions including full load, short circuits, and extreme temperatures to ensure robust operation.

(For reference only)