Details

---

BUY 7D75A-050EHR https://www.utsource.net/itm/p/6528106.html

Parameter	Value
Part Number	7D75A-050EHR
Type	Relay
Coil Voltage	5 VDC
Coil Power	1.25 W
Contact Form	SPDT (Single Pole Double Throw)
Contact Rating	10 A, 250 VAC
Insulation Resistance	100 M惟 min @ 500 VDC
Dielectric Strength	2000 VAC rms for 1 minute
Operating Temperature	-40掳C to +85掳C
Storage Temperature	-40掳C to +85掳C
Humidity	95% RH max at 40掳C
Terminal Type	Solder Lug
Mounting	Panel Mount
Dimensions	26.2 x 16.5 x 33.5 mm (LxWxH)
Weight	30 g

Instructions:

1. Installation:

   • Ensure the relay is mounted in a location that does not exceed the operating temperature range.
   • Secure the relay using the provided mounting hardware or appropriate method for panel mount.

2. Wiring:

   • Connect the coil terminals to the control circuit ensuring correct polarity.
   • Connect load and line wires to the contact terminals as per your application requirements.

3. Operation:

   • Apply the rated voltage to the coil to energize the relay and switch the contacts.
   • Verify that the contacts operate correctly by testing the continuity between the contact terminals.

4. Maintenance:

   • Regularly inspect the relay for any signs of damage or wear.
   • Ensure connections remain tight and secure over time.

5. Safety:

   • Always disconnect power before performing any maintenance or wiring changes.
   • Use appropriate personal protective equipment when handling electrical components.

(For reference only)