Details

---

BUY SKFH150/09DS https://www.utsource.net/itm/p/6528688.html

Parameter	Value
Part Number	SKFH150/09DS
Type	Ball Bearing
Inner Diameter (d)	45 mm
Outer Diameter (D)	72 mm
Width (B)	18 mm
Rated Dynamic Load	36.2 kN
Rated Static Load	20.2 kN
Limiting Speed	18,000 rpm
Seal Type	Double Sided Rubber Seals
Cage Material	Brass
Lubrication	Grease
Operating Temperature	-30掳C to +120掳C

Instructions for Use:

1. Installation:

   • Ensure the shaft and housing are clean and free from burrs or sharp edges.
   • Use appropriate installation tools to avoid damaging the bearing seals.
   • Do not apply force directly to the bearing rings.

2. Mounting:

   • Mount the bearing with the correct axial clearance.
   • Tighten mounting bolts gradually and evenly to ensure proper seating.

3. Lubrication:

   • The bearing is pre-lubricated at the factory; additional lubrication is generally not required.
   • If re-lubrication is necessary, use a grease compatible with the existing grease.

4. Operation:

   • Operate within the specified temperature range to prevent damage to seals and lubricant.
   • Monitor for unusual noises or vibrations which may indicate misalignment or wear.

5. Maintenance:

   • Regularly inspect for signs of wear or contamination.
   • Replace bearings if any damage or excessive wear is detected.

6. Storage:

   • Store in original packaging in a dry, clean environment.
   • Avoid exposure to moisture, dust, and direct sunlight.

(For reference only)