Details

---

BUY MEK95-06DA https://www.utsource.net/itm/p/6529468.html
RES, 1K 1% 1/8W AXIAL

Parameter	Description	Value	Unit
Device Type	Description of the device type	MEMS Accelerometer	-
Supply Voltage	Operating voltage range	1.7 to 3.6	V
Interface	Communication interface	I2C, SPI	-
Measurement Range	Range of acceleration measurement	卤2g, 卤4g, 卤8g, 卤16g	g
Sensitivity	Sensitivity at 卤2g range	256	LSB/g
Bandwidth	Output data rate	Up to 1600	Hz
Power Consumption	Current consumption in active mode	90	渭A
Package	Type of package	LGA-14	-
Operating Temp	Temperature range for operation	-40 to +85	掳C

Instructions for MEK95-06DA

1. Power Supply Setup:

   • Connect the power supply pins (VDD and GND) ensuring the voltage is within the specified range (1.7V to 3.6V).

2. Interface Configuration:

   • Choose either I2C or SPI interface based on your application requirements.
   • Configure the necessary pins for the selected communication protocol.

3. Measurement Range Selection:

   • Set the desired measurement range (卤2g, 卤4g, 卤8g, 卤16g) through configuration registers via the interface.

4. Bandwidth Setting:

   • Adjust the output data rate according to your application needs using the appropriate register settings.

5. Data Reading:

   • Read the acceleration data from the sensor registers using the configured interface.

6. Power Management:

   • For low-power applications, utilize the power-saving modes by configuring the relevant registers.

7. Handling and Installation:

   • Handle the device with care to avoid damage to the sensitive MEMS structure.
   • Ensure proper installation orientation based on the direction of intended measurement.

8. Environmental Considerations:

   • Operate the device within the specified temperature range (-40掳C to +85掳C) for optimal performance.

Note: Detailed register maps and specific configuration settings should be referred from the datasheet provided by the manufacturer.

(For reference only)