Details

---

BUY BSM300GA120DN2SE3256 https://www.utsource.net/itm/p/6529590.html
IGBT Module

Parameter	Description
Part Number	BSM300GA120DN2SE3256
Type	IGBT Module
Collector-Emitter Voltage (Vce)	1200 V
Collector Current (Ic)	300 A at Tc = 25°C, 240 A at Tc = 80°C
Switching Frequency	Optimized for frequencies up to 20 kHz
Thermal Resistance (Rth,jc)	0.12 K/W
Package Type	SEMITOP S3
Insulation Material	Ceramic substrate with direct copper bonding (DCB)
Operating Temperature Range	-40°C to +150°C
Storage Temperature Range	-55°C to +150°C
Gate-Emitter Voltage (Vge)	±20 V
Dissipation Power (Ptot)	375 W

Instructions:

1. Installation:

   • Ensure the mounting surface is clean and flat.
   • Apply a thin layer of thermal paste if not pre-applied on the module.
   • Tighten the screws evenly to avoid uneven pressure distribution.

2. Electrical Connections:

   • Connect the gate, emitter, and collector terminals as per your circuit design.
   • Ensure all connections are secure and insulated properly to prevent short circuits.

3. Cooling:

   • Use an appropriate heatsink or cooling system to maintain the operating temperature within the specified range.
   • Monitor the temperature during operation to ensure it does not exceed the maximum limit.

4. Handling:

   • Handle with care to avoid mechanical damage.
   • Avoid exposing the module to excessive humidity and corrosive environments.

5. Testing:

   • Before full-scale operation, perform a low-power test to ensure all connections and settings are correct.
   • Regularly inspect the module for any signs of wear or damage.

6. Safety Precautions:

   • Always follow proper safety protocols when working with high voltage and current.
   • Disconnect power and discharge capacitors before handling the module.

(For reference only)