Details

---

BUY AD567JD https://www.utsource.net/itm/p/6541089.html
IC DAC 12BIT A-OUT 28CDIP

Parameter	Description	Min	Typ	Max	Unit
Supply Voltage	Operating voltage range	4.5	-	16	V
Output Current	Maximum output current	-	20	-	mA
Bandwidth	Small signal bandwidth	-	2.8	-	MHz
Slew Rate	Rate of change of output voltage	-	1.2	-	V/μs
Input Offset Volt	Voltage difference between inputs	-	2	-	mV
Input Bias Current	Current flowing into the input terminals	-	30	-	nA
Power Consumption	Typical power consumption	-	7	-	mW

Instructions for AD567JD

1. Power Supply Connection:

   • Connect the positive supply pin to a voltage source within the specified range (4.5V to 16V).
   • Ensure the negative supply pin is connected to ground.

2. Signal Input:

   • Apply the input signal to the designated input pins.
   • Be cautious not to exceed the maximum input voltage levels to prevent damage.

3. Output Configuration:

   • The output can drive loads up to the specified maximum current (20mA). Ensure the load resistance is appropriate to avoid overheating or damage.

4. Operational Considerations:

   • For optimal performance, operate within the specified temperature range and ensure proper heat dissipation if operating at higher temperatures or currents.
   • Use bypass capacitors near the power supply pins to reduce noise and improve stability.

5. Handling Precautions:

   • This device is sensitive to electrostatic discharge (ESD); handle with appropriate ESD precautions.
   • Avoid exposing the device to excessive mechanical stress, moisture, or corrosive environments.

Note: Always refer to the latest datasheet from the manufacturer for the most accurate and detailed specifications and guidelines.

(For reference only)