Details

---

BUY OPA627AP https://www.utsource.net/itm/p/6572366.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	Vcc		±2.25		±18	V
Supply Current	Icc	per amplifier		3.6		mA
Input Offset Voltage	Vio	Initial	-0.4		+0.4	mV
Input Bias Current	Ib		-20		+20	nA
Input Offset Current	Ios	Initial	-5		+5	nA
Common-Mode Rejection Ratio	CMRR	@ 1kHz	90			dB
Power-Supply Rejection Ratio	PSRR	@ 1kHz	100			dB
Large Signal Voltage Gain	Av	@ G = 10, RL = 1kΩ		200		V/mV
Slew Rate	SR			1700		V/μs
Bandwidth (-3dB)	BW	G = +1, RL = 1kΩ		250		MHz
Output Voltage Swing	Vos	@ Vcc = ±15V, RL = 1kΩ	±12		±13.5	V

Instructions for Use:

1. Supply Voltage: The OPA627AP can operate from a supply voltage range of ±2.25V to ±18V. Ensure the power supply is stable and within these limits.
2. Biasing and Decoupling: Use proper bypass capacitors (typically 0.1 μF) close to the power supply pins to minimize noise and transient effects.
3. Input Signals: Be cautious with input signals to avoid exceeding the common-mode input voltage range, which is typically within the supply rails.
4. Output Load: For optimal performance, ensure the output load resistance is appropriate. The device can drive loads down to 600 Ω.
5. Stability Considerations: The OPA627AP is unity-gain stable but can be used in higher gain configurations as well. Ensure compensation if needed for stability.
6. Handling Precautions: This device is sensitive to electrostatic discharge (ESD). Follow proper ESD handling procedures during installation and testing.
7. Operating Temperature Range: The operating temperature range is specified from -40°C to +85°C. Ensure the ambient temperature does not exceed these limits.

For detailed specifications and further instructions, refer to the manufacturer's datasheet.

(For reference only)