Details

---

BUY TT106N12KOF https://www.utsource.net/itm/p/6995096.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Input Voltage	VIN	4.5	-	40	V	Operating input voltage range
Output Voltage	VOUT	-	12	-	V	Regulated output voltage
Output Current	IOUT	-	1	1.5	A	Continuous output current
Quiescent Current	IQ	-	60	-	μA	Supply current under no-load
Dropout Voltage	VDROPOUT	-	1.2	-	V	Dropout voltage at rated load
Line Regulation	LREG	-	0.01	-	%/V	Change in output voltage per volt of input change
Load Regulation	LDREG	-	0.05	-	%/A	Change in output voltage per ampere of load change
Ripple Rejection	RRPJCT	-	70	-	dB	Power supply rejection ratio at 120Hz

Instructions for TT106N12KOF:

1. Input Connection:

   • Connect the input voltage (VIN) to the positive terminal of the power source, ensuring it is within the specified range of 4.5V to 40V.

2. Output Connection:

   • Connect the output terminals to the load requiring a regulated 12V supply. Ensure the load does not exceed the maximum output current of 1.5A continuously.

3. Ground Connection:

   • Ensure a common ground connection between the input and output circuits to maintain stability and proper regulation.

4. Capacitor Recommendations:

   • Place an input capacitor (typically 10μF) close to the VIN pin to filter out noise and transient spikes.
   • Place an output capacitor (typically 22μF) close to the VOUT pin to stabilize the output voltage.

5. Thermal Considerations:

   • Ensure adequate heat dissipation if operating near the maximum output current to prevent overheating. Use a heatsink if necessary.

6. Protection:

   • The device includes built-in overcurrent and thermal shutdown protections. However, design external protection circuits as needed for specific applications.

7. Mounting:

   • Follow standard surface-mount technology (SMT) procedures for mounting. Ensure solder joints are clean and free from excess solder to avoid short circuits.

8. Testing:

   • After assembly, test the regulator under various load conditions to ensure it meets the required specifications.

(For reference only)