Details

---

BUY TPD2005F(EL,F) https://www.utsource.net/itm/p/7279549.html
Intelligent Power Devices (IPDs), Toshiba The TPD1030F is a 2-in-1 Low-Side Switch The TPD2005F is an 8-channel High-Side Switch Array The TPD2007F is an 8-channel Low-Side Switch Array Switching applications for Motors, Solenoids, and Lamp Drivers

Parameter	Symbol	Min	Typ	Max	Unit	Description
Input Voltage	V_IN	1.8	-	5.5	V	Operating voltage range
Output Voltage	V_OUT	-	0	-	V	Output voltage (GND referenced)
Quiescent Current	I_Q	-	1	-	μA	Supply current at no load
Reverse Leakage Current	I_RL	-	1	-	nA	Reverse leakage current per channel
Channel-to-Channel Capacitance	C_C2C	-	0.4	-	pF	Capacitance between channels
ESD Rating (Human Body Model)	ESD_HBM	4000	-	-	V	Electrostatic discharge tolerance

Instructions for TPD2005F(EL,F):

1. Power Supply Connection:

   • Connect the input voltage (V_IN) to a power supply within the specified operating voltage range (1.8V to 5.5V).
   • Ensure that the ground (GND) is properly connected.

2. Signal Routing:

   • Route signals through the device, ensuring they do not exceed the maximum ratings.
   • The device provides protection for two signal lines, so connect each line to its respective pin.

3. Handling and Installation:

   • Handle the device with care to avoid damage from electrostatic discharge (ESD). The device has an ESD rating of 4000V (HBM).
   • Install in a clean environment to prevent contamination or damage.

4. Testing:

   • After installation, verify the functionality by checking the quiescent current and ensuring it remains within the typical value (1μA).
   • Test the reverse leakage current to ensure it does not exceed the typical value (1nA).

5. Storage:

   • Store in a dry, cool place away from direct sunlight and sources of heat.
   • Follow proper anti-static storage procedures to maintain device integrity.

6. Troubleshooting:

   • If the device fails to operate correctly, check all connections for proper seating and continuity.
   • Verify that the input voltage is within the specified range and that the supply current is as expected.

(For reference only)