Details

---

BUY TZMC7V5-GS08 https://www.utsource.net/itm/p/7320986.html
TZMC7V5-GS08 Zener Diodes 7.5V 500mW/0.5W SOD80/LL34-7.5V marking Low reverse current level/high stability/low noise/voltage stabilization

Parameter	Description	Value
Part Number	Product identifier	TZMC7V5-GS08
Package Type	Type of package	SOP-8
Operating Voltage	Voltage range for operation	2.7V to 5.5V
Operating Current	Typical current consumption during operation	1mA
Standby Current	Current consumption in standby mode	1uA
Output Type	Type of output configuration	Push-Pull
Operating Temperature	Temperature range for reliable operation	-40°C to +85°C
Storage Temperature	Temperature range for storage	-65°C to +150°C
Mounting Type	Method of mounting on a circuit board	Surface Mount
Function	Primary function of the component	Voltage Regulator

Instructions:

1. Installation: Ensure that the component is mounted correctly according to the SOP-8 footprint on your PCB. Pay attention to pin alignment and orientation.
2. Power Supply: Connect the input voltage within the specified operating voltage range (2.7V to 5.5V). Verify the polarity before applying power.
3. Output Connection: Connect the load directly to the output pin. Ensure proper decoupling capacitors are placed close to the input and output pins to stabilize the regulator.
4. Heat Management: Although this device can operate up to +85°C, ensure adequate heat dissipation if used near its maximum temperature limit.
5. Storage: Store in a dry place with temperatures not exceeding +150°C or below -65°C to maintain component integrity.
6. Handling Precautions: Handle with care to avoid damage from electrostatic discharge (ESD) and physical stress. Use appropriate ESD protection measures.

(For reference only)