Details

---

BUY NVP2010 https://www.utsource.net/itm/p/7959354.html

Parameter	Description
Supply Voltage (VDD)	Operating voltage range: 2.7V to 5.5V
Input Voltage Range	Differential input voltage range: ±200mV
Output Voltage Swing	Rail-to-rail output swing, dependent on load and supply voltage
Bandwidth	Unity-gain bandwidth: 1MHz
Slew Rate	Minimum slew rate: 0.6V/μs
Quiescent Current	Typical quiescent current: 400μA
Common-Mode Rejection Ratio (CMRR)	Minimum CMRR: 80dB at DC
Power Supply Rejection Ratio (PSRR)	Minimum PSRR: 90dB at 1kHz
Operating Temperature Range	Extended industrial temperature range: -40°C to +85°C

Instructions for Use

1. Power Supply Connections:

   • Connect the positive supply voltage (VDD) and ground (GND). Ensure that the supply voltage is within the specified operating range.

2. Input Signal Connections:

   • Connect the differential input signals to the IN+ and IN- pins. The input voltage should not exceed the specified differential input voltage range.

3. Output Configuration:

   • The output pin (OUT) can be connected directly to a load or further stages of amplification. Ensure that the load impedance is compatible with the output drive capability of the NVP2010.

4. Decoupling Capacitors:

   • Place decoupling capacitors close to the power supply pins to reduce noise and transient effects. A typical value is 0.1μF ceramic capacitor.

5. Stability Considerations:

   • The NVP2010 is unity-gain stable. However, if used in applications requiring higher stability margins, consider adding compensation components as per application requirements.

6. Thermal Management:

   • Ensure adequate heat dissipation by providing a proper PCB layout and possibly heatsinks if operating near the maximum temperature limit.

7. Handling Precautions:

   • Handle the device with care to avoid electrostatic discharge (ESD) damage. Use appropriate ESD protection measures during assembly and handling.

8. Testing and Validation:

   • After installation, verify the operation of the circuit under expected conditions. Perform tests to ensure that all parameters are within specifications.

(For reference only)