Details

---

BUY LT1050CS8 https://www.utsource.net/itm/p/8046324.html
New and original

Parameter	Min	Typical	Max	Unit	Description
Supply Voltage	2.7		36	V	Operating supply voltage range
Input Offset Voltage		50	150	μV	Voltage difference between the two inputs
Input Bias Current		50	150	nA	Average current into both input terminals
Slew Rate		0.4		V/μs	Rate of change of output voltage
Bandwidth (Small Sig)		1.2		MHz	Frequency at which gain drops to -3 dB
Output Voltage Swing			Vcc-2	V	Maximum peak-to-peak swing without clipping
Quiescent Current		850		μA	Supply current with no load
Common Mode Rejection		90	100	dB	Ability to reject common-mode signals

Instructions for LT1050CS8:

1. Power Supply Connections:

   • Connect the positive supply pin (V+) to a power source within the specified range (2.7V to 36V).
   • Connect the negative supply pin (V-) to ground or a negative supply if using a split supply.

2. Input Connections:

   • Apply the signal to be amplified to the non-inverting (+) and inverting (-) input pins.
   • Ensure that the input voltage levels stay within the common mode input voltage range.

3. Output Connections:

   • Connect the output pin to the load or next stage of the circuit.
   • The output can swing from near ground to approximately 2V below the positive supply voltage.

4. Biasing and Feedback:

   • Use external resistors to set up the desired gain and biasing conditions.
   • For stable operation, ensure proper feedback network design to avoid oscillation.

5. PCB Layout Considerations:

   • Keep power and ground connections short and direct to minimize noise.
   • Place bypass capacitors close to the power pins to filter out high-frequency noise.

6. Operating Temperature:

   • Ensure the operating environment stays within the specified temperature range to maintain performance characteristics.

Note: Always refer to the latest datasheet from the manufacturer for detailed specifications and application notes.

(For reference only)