Details

---

BUY MX29GL128ELT2I-90G https://www.utsource.net/itm/p/8147220.html

Parameter	Description
Part Number	MX29GL128ELT2I-90G
Manufacturer	Macronix
Type	Flash Memory
Capacity	128 Mbit (16 MByte)
Voltage - Supply (Vcc)	2.7 V to 3.6 V
Interface	SPI (Serial Peripheral Interface)
Package Type	TSSOP-24 (Thin Small Outline Package with 24 pins)
Operating Temperature	-40°C to +85°C
Speed	90 MHz (Maximum clock frequency)
Memory Architecture	NOR
Write Cycle Time	2 ms (Typical)
Erase Sector Size	4 KBytes
Endurance	100,000 Program/Erase cycles
Data Retention	20 years at 25°C

Instructions:

1. Power Supply: Ensure the supply voltage is within the specified range of 2.7 V to 3.6 V.
2. SPI Configuration: Configure the SPI interface correctly for communication. The chip select (CS), serial clock (SCK), master out slave in (MOSI), and master in slave out (MISO) lines must be properly connected.
3. Initialization: Before any operation, initialize the device by setting up the SPI parameters (clock speed, polarity, phase).
4. Write Operations: Perform write operations using the provided commands, ensuring that the write enable latch (WEL) is set before writing data.
5. Erase Operations: Erase sectors or blocks using the appropriate erase command sequences. Ensure no write operation is in progress.
6. Read Operations: Use read commands to access data from the memory. Adjust the SPI clock speed for optimal performance.
7. Protection: Implement software protection features such as write protection if required.
8. Temperature Considerations: Operate within the temperature range specified to ensure reliable performance.
9. Handling Care: Handle the component with care to avoid damage to the pins and package integrity.

For detailed command sets and timing diagrams, refer to the official datasheet provided by Macronix.

(For reference only)