Details

---

BUY IT8712F-S/JX-L https://www.utsource.net/itm/p/8155399.html

Parameter	Description
Device Type	Microcontroller
Package Type	QFN48
Operating Voltage	2.5V to 5.5V
Operating Temperature	-40°C to +85°C
Interface Support	I2C, SMBus, SPI
GPIO Pins	26 pins
PWM Channels	6 channels
ADC Channels	12-bit, 8 channels
Timer/Counters	3 x 16-bit timer/counters
Watchdog Timer	Yes
UART Interfaces	2 UARTs
I2S Interface	Yes
SPI Flash Support	Yes
DMA Channels	4 channels
Power Management	Supports power saving modes

Instructions for IT8712F-S/JX-L

1. Power Supply Connection:

   • Connect the VCC pin to a stable power supply within the operating voltage range (2.5V to 5.5V).
   • Ensure the GND pin is properly connected to the system ground.

2. Clock Configuration:

   • Configure the internal or external clock source as per the application requirement.
   • Use the provided clock configuration registers to set the desired frequency.

3. Interface Initialization:

   • Initialize I2C, SMBus, or SPI interfaces using the corresponding initialization routines in the firmware.
   • Set up the communication parameters such as baud rate and data format.

4. GPIO Configuration:

   • Configure GPIO pins as input, output, or alternate functions using the GPIO configuration registers.
   • Use the GPIO interrupt feature for event-driven applications.

5. PWM Setup:

   • Configure PWM channels for generating precise timing signals.
   • Adjust duty cycle and frequency through the PWM control registers.

6. ADC Operation:

   • Select the ADC channels and configure the sampling rate.
   • Start conversions and read the results from the ADC data registers.

7. Timer/Counter Usage:

   • Set up timer/counters for timekeeping or pulse counting.
   • Configure interrupt generation on overflow or match events.

8. UART Communication:

   • Initialize UART interfaces with appropriate settings for serial communication.
   • Enable interrupts for receiving and transmitting data asynchronously.

9. I2S Configuration:

   • Configure the I2S interface for audio data transfer.
   • Set up the bit clock, word select, and data lines.

10. SPI Flash Support:

    • Initialize SPI flash memory for storing firmware or data.
    • Use DMA channels for efficient data transfer between the microcontroller and SPI flash.

11. Power Management:

    • Implement power-saving modes to reduce power consumption during idle periods.
    • Use the watchdog timer to ensure reliable operation.

For detailed register descriptions and programming examples, refer to the datasheet and application notes provided by the manufacturer.

(For reference only)