Details

---

BUY LTC6240IS5#PBF https://www.utsource.net/itm/p/8193337.html
New and original

Parameter	Min	Typ	Max	Unit	Description
Supply Voltage	2.7	-	5.25	V	Operating supply voltage range
Quiescent Current	-	160	-	μA	Supply current at no load
Input Offset Voltage	-	300	-	μV	Maximum input offset voltage
Input Bias Current	-	0.5	-	pA	Typical input bias current
Slew Rate	-	1.4	-	V/μs	Slew rate
Bandwidth (Small Signal)	-	2.8	-	MHz	Small signal bandwidth
Output Voltage Swing	-	-	-	V	Rail-to-rail output swing, dependent on load and supply voltage
CMRR	-	100	-	dB	Common-mode rejection ratio
PSRR	-	100	-	dB	Power supply rejection ratio

Instructions for Use:

1. Supply Voltage: Ensure the supply voltage is within the specified range of 2.7V to 5.25V.
2. Quiescent Current: The device operates with a typical quiescent current of 160μA. Ensure that this does not exceed system power constraints.
3. Input Offset Voltage: For precision applications, consider the maximum input offset voltage of 300μV.
4. Input Bias Current: With a typical input bias current of 0.5pA, this op-amp is suitable for high impedance sources.
5. Slew Rate: Design circuits considering the slew rate of 1.4V/μs to avoid distortion in fast-changing signals.
6. Bandwidth: The small signal bandwidth of 2.8MHz should be considered for AC-coupled applications.
7. Output Voltage Swing: The output can swing rail-to-rail, but check specific conditions based on load and supply voltage.
8. CMRR and PSRR: Both parameters are important for noise-sensitive applications; ensure these meet your design requirements.

For detailed specifications and additional information, refer to the official Linear Technology (now part of Analog Devices) datasheet for the LTC6240IS5#PBF.

(For reference only)