Details

---

BUY CH374S https://www.utsource.net/itm/p/8378028.html

Parameter	Description	CH374S Value
Operating Voltage	Supply voltage range for operation	3.0V to 5.5V
Interface	Type of interface supported	USB, SPI, I2C
Data Rate	Maximum data transfer rate	Up to 12 Mbps (USB Full Speed)
Operating Temp	Temperature range for reliable operation	-40°C to +85°C
Storage Temp	Temperature range for storage without damage	-65°C to +150°C
Package Type	Physical package type	SOP-16
Input/Output	Number of I/O lines	8-bit parallel or serial interface
Power Consumption	Typical power consumption	Low, depends on operating conditions

Instructions for Using CH374S

1. Power Supply Connection:

   • Connect the VCC pin to your system's power supply within the operating voltage range.
   • Ensure GND is properly connected to the ground.

2. Interface Selection:

   • Choose the appropriate interface mode (USB, SPI, or I2C) based on your application needs.
   • Configure the interface settings via software or hardware as specified in the datasheet.

3. Data Transfer Setup:

   • For USB mode, connect the D+ and D- pins to the USB bus lines.
   • For SPI/I2C modes, connect the SCLK, MOSI, MISO (for SPI), SDA, and SCL (for I2C) to the respective lines.

4. Firmware/Driver Installation:

   • Install necessary drivers/firmware if required for USB communication.
   • Follow the manufacturer’s guidelines for specific setup instructions.

5. Operating Environment:

   • Ensure the device operates within specified temperature ranges to avoid damage or malfunction.
   • Keep the device away from high humidity and corrosive environments.

6. Testing and Troubleshooting:

   • After setup, test the device using a simple read/write operation to ensure proper functionality.
   • Refer to the troubleshooting section in the datasheet for any issues encountered.

Note: Detailed configuration and programming specifics can be found in the official CH374S datasheet provided by the manufacturer.

(For reference only)