Details

---

BUY OPA1602AIDR https://www.utsource.net/itm/p/8417039.html

Parameter	Conditions	Min	Typ	Max	Unit
Supply Voltage	V+ to V-	-0.3		36	V
Input Offset Voltage	VCM = 2V to (V+ - 2V), TA = 25°C	-1	0.4	1	mV
Input Bias Current	VIN = 0V, f = 1kHz	-100	8	100	nA
Input Voltage Noise	f = 1kHz, TA = 25°C		1.7		nV/√Hz
Input Current Noise	f = 1kHz, TA = 25°C		1.6		pA/√Hz
Slew Rate	RL = 1kΩ, CL = 10pF		3		V/μs
Large Signal Bandwidth	VOUT = 2VPP, RL = 1kΩ		9		MHz
Gain Bandwidth Product	G = +1		18		MHz
Output Voltage Swing	RL = 1kΩ, IOUT = ±1mA, TA = 25°C	±13.5		±14	V
Quiescent Current	Per Amplifier, TA = 25°C		2.7		mA

Instructions for Using OPA1602AIDR

1. Power Supply:

   • Ensure the supply voltage is within the range of -0.3V to 36V.
   • Use decoupling capacitors close to the power pins to minimize noise.

2. Input Configuration:

   • Keep input voltages within the common-mode range to avoid phase inversion or damage.
   • For best performance, keep inputs within 2V to (V+ - 2V).

3. Biasing and Stabilization:

   • Apply appropriate biasing if using in configurations like transimpedance amplifiers.
   • Use feedback resistors to stabilize gain and bandwidth as needed.

4. Noise Considerations:

   • The low noise characteristics make it suitable for audio applications; ensure layout minimizes noise pickup.

5. Output Load:

   • Ensure output load resistance is at least 1kΩ for optimal performance.
   • For maximum output swing, match the load impedance to the recommended values.

6. Thermal Management:

   • Operate within specified temperature ranges to maintain reliability.
   • Provide adequate heat sinking if operating near maximum power dissipation.

7. Handling Precautions:

   • Handle with care to prevent electrostatic discharge (ESD) damage.
   • Follow manufacturer guidelines for soldering and assembly processes.

(For reference only)