Details

---

BUY LT3010EMS8E#PBF https://www.utsource.net/itm/p/8602591.html
IC REG LINEAR POS ADJ 50MA 8MSOP

Parameter	Description	Value
Input Voltage Range	Operating input voltage range	2.5V to 15V
Output Voltage Range	Adjustable output voltage range	0.8V to 14V
Output Current	Maximum continuous output current	3A
Quiescent Current	Supply current in regulation (typical)	2mA
Dropout Voltage	Dropout voltage at full load (maximum)	350mV
PSRR	Power supply rejection ratio at 100kHz (minimum)	60dB
Package Type	Surface mount package	MS8E
Operating Temperature	Junction temperature range	-40°C to 125°C

Instructions for Use:

1. Input Connection: Connect the input voltage within the specified range (2.5V to 15V) to the IN pin.
2. Output Configuration: Set the desired output voltage using an external resistor divider network connected to the ADJ pin.
3. Output Capacitor: Place a capacitor on the output to ensure stability. A typical value is 10μF ceramic or tantalum.
4. Thermal Consideration: Ensure adequate heat dissipation if operating near maximum power conditions.
5. PCB Layout: Keep the input and output capacitors close to the device for optimal performance and stability.
6. By-Pass Capacitors: It is recommended to use by-pass capacitors from the IN pin to GND and from the OUT pin to GND to reduce noise.
7. Power-On Reset: The device does not have a power-on reset feature; ensure proper sequencing if used in systems requiring it.

For detailed design considerations and application circuits, refer to the Linear Technology (now Analog Devices) datasheet for the LT3010EMS8E#PBF.

(For reference only)