Details

---

BUY LTA1002NT/N1 https://www.utsource.net/itm/p/9105428.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	Vcc		2.7		5.5	V
Input Offset Voltage	Vos	Initial (T = +25°C)	-0.6	0	0.6	mV
Input Bias Current	Ib	T = +25°C	-1	0	1	nA
Input Offset Current	Ios	T = +25°C	-0.3	0	0.3	nA
Common Mode Rejection Ratio	CMRR	f = 0.1 Hz to 10 Hz, RL = 10kΩ	90			dB
Power Supply Rejection Ratio	PSRR	f = 0.1 Hz to 10 Hz	96			dB
Slew Rate	SR		0.4			V/μs
Bandwidth (-3dB)	BW	G = +1, VS = ±2.5V	1.2			MHz
Output Voltage Swing	Vosw	RL = 10kΩ, VS = ±2.5V	-2.3		2.3	V

Instructions for LTA1002NT/N1:

1. Power Supply:

   • Ensure the supply voltage is within the specified range of 2.7V to 5.5V.
   • Use a stable power source to avoid fluctuations that can affect performance.

2. Input Signals:

   • Keep input signals within the common-mode input voltage range to prevent distortion.
   • Be mindful of the input bias and offset currents which can influence the accuracy of the input signal.

3. Output Configuration:

   • The output voltage swing should not exceed the power supply voltages to avoid clipping or damage.
   • Connect appropriate load resistors to match the output impedance for optimal performance.

4. Operating Temperature:

   • The device is designed to operate within a specific temperature range. Check the datasheet for exact limits to ensure reliable operation.

5. Handling Precautions:

   • Handle with care to avoid electrostatic discharge (ESD) damage.
   • Follow standard handling protocols for sensitive electronic components.

6. Mounting and Layout:

   • Ensure proper mounting on the PCB to maintain thermal stability.
   • Optimize layout to minimize noise and interference, especially for high-frequency applications.

7. Testing:

   • Before deploying in final designs, thoroughly test the device under all expected operating conditions.
   • Verify parameters like bandwidth, slew rate, and power supply rejection ratio meet application requirements.

(For reference only)