Details
BUY 24C01-6 https://www.utsource.net/itm/p/9785310.html
| Parameter | Description | Value | 
|---|---|---|
| Device Type | Serial EEPROM | 24C01-6 | 
| Organization | I2C Interface | |
| Memory Size | 1K bit (128 bytes) | |
| Operating Voltage | VCC | 1.8V to 5.5V | 
| Operating Current | Active Current | 1mA max | 
| Standby Current | Standby Current | 1μA max | 
| Write Cycle Time | Typical Write Cycle Time | 5ms max | 
| Data Retention | Data Retention Time | 200 years min | 
| Write Cycles | Endurance for Each Memory Cell | 1,000,000 | 
| Operating Temp. | Operating Temperature Range | -40°C to 85°C | 
| Package | Package Type | SOIC-8 | 
Instructions:
- Power Supply: Connect the VCC pin to a power supply within the operating voltage range (1.8V to 5.5V). Ground the GND pin.
 - I2C Interface Setup:
- Connect SDA (Data Line) and SCL (Clock Line) to the respective lines of the microcontroller or host system.
 - Ensure pull-up resistors are connected to both SDA and SCL lines.
 
 - Address Configuration:
- The device has a fixed I2C address unless A0, A1, A2 pins are used for address selection.
 
 - Write Operation:
- Start condition on the I2C bus.
 - Send the control byte (device address + write command).
 - Send the memory address where data is to be written.
 - Transmit the data byte(s) to be written.
 - Stop condition on the I2C bus.
 - Wait for at least 5ms before starting another write cycle to allow completion of the previous write operation.
 
 - Read Operation:
- Start condition on the I2C bus.
 - Send the control byte (device address + write command).
 - Send the memory address from which data is to be read.
 - Repeated start condition.
 - Send the control byte (device address + read command).
 - Read the data byte(s).
 - Send an NACK after the last byte you want to read.
 - Stop condition on the I2C bus.
 
 - Handling:
- Ensure that the device is not exposed to voltages outside its specified operating range.
 - Avoid exceeding the maximum operating temperature and humidity levels to prevent damage.
 
 - Storage:
- Store in a dry environment to avoid moisture damage.
 
 
View more about 24C01-6 on main site
        