Details

---

BUY LM358SNG https://www.utsource.net/itm/p/9900541.html
IC OPAMP GP 2 CIRCUIT 8DIP

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	-	3	-	30	V
Input Offset Voltage	VIO	-	-	2	5	mV
Input Bias Current	IB	-	-	45	-	nA
Slew Rate	SR	-	-	0.5	-	V/μs
Output Voltage Swing	VOS	VCC=±15V, RL=2kΩ	-2	-	+2	V
Common-Mode Rejection Ratio	CMRR	-	-	85	-	dB
Power Supply Rejection Ratio	PSRR	-	-	85	-	dB
Bandwidth	fBW	G=+1	-	1	-	MHz

Instructions for LM358SNG

1. Power Supply: Ensure the supply voltage is within the range of 3V to 30V. The LM358SNG can operate with single or split supplies.

2. Input Connections: Connect input signals ensuring they remain within the common-mode input voltage range, which extends from ground to V_CC - 1.5V.

3. Output Load: The output can swing from 0V to approximately V_CC - 1.5V. Ensure the load resistance is appropriate to avoid excessive power dissipation.

4. Biasing and Feedback: Use external resistors to set up biasing and feedback loops. Properly designed feedback ensures stability and desired gain characteristics.

5. Decoupling Capacitors: Place decoupling capacitors close to the power supply pins to reduce noise and transient effects.

6. Operating Temperature: The device is specified to operate over a temperature range of -40°C to +85°C. Ensure the application environment stays within these limits.

7. Handling Electrostatic Discharge (ESD): Handle the IC carefully to prevent damage from ESD. Use proper grounding and anti-static equipment when handling.

8. Mounting and PCB Design: Follow good PCB layout practices. Keep signal traces short, especially for high-frequency applications, and ensure adequate heat sinking if necessary.

(For reference only)