Details

---

BUY TC358870XBG https://www.utsource.net/itm/p/11710922.html

Parameter	Description
Product Name	TC358870XBG
Type	Video Decoder and Encoder
Interface	MIPI-CSI2, BT.656, RGB, YCbCr 4:2:2/4:4:4
Power Supply Voltage (VDDIO)	1.8V ± 5%
Power Supply Voltage (VDDCORE)	1.05V ± 5%
Operating Temperature Range	-40°C to +85°C
Input Video Standards	NTSC, PAL, SECAM
Output Data Format	YCbCr 4:2:2, RGB, Raw Bayer
MIPI CSI-2 Lane Configurations	1, 2, or 4 lanes
Package Type	CSP (Chip Scale Package)
Pin Count	129

Instructions for Use:

1. Power Supply Setup: Ensure that the power supply voltages are set correctly. VDDIO should be 1.8V and VDDCORE should be 1.05V. Use appropriate decoupling capacitors close to the power pins.

2. Clock Configuration: The device requires an external clock input. Refer to the datasheet for specific clock frequency requirements based on the video standard being used.

3. Input Selection: Configure the input video standard (NTSC, PAL, or SECAM) through the control registers. This can typically be done via I2C interface.

4. Output Interface Configuration: Choose the desired output data format and configure the MIPI-CSI2 lane settings as required by your application. The configuration is usually done via the I2C interface.

5. Thermal Management: Given the operating temperature range, ensure adequate thermal management, such as heat sinks or cooling solutions if necessary, especially in environments approaching the upper temperature limit.

6. Firmware/Software Setup: Use the provided SDK or development tools to configure the device parameters and integrate it into your system. Follow the programming guide for detailed register settings.

7. Testing and Validation: After setup, test the device with known video inputs to verify correct operation. Adjust configurations as needed based on test results.

For more detailed information, refer to the official datasheet and application notes provided by Toshiba.

(For reference only)